Rolex watch broke out do not go how to do

replica watches wheel teeth are not fault, usually the internal gear of the rolex replica watches there is a fault caused. This type of rolex replica failure is easy to appear in the box teeth, the central gear. In addition, because the dial dial when the wheel is too tight, across the teeth teeth crooked phenomenon. If you find the teeth broken, in general, should be a new round. How to correct the timing of the gears of the watch? How to correct the teeth and the teeth of the watch is not a fault, usually the internal gear of the watch has caused a failure. This type of watch failure is easy to appear in the box teeth, the central gear. In addition, because the dial dial when the wheel is too tight, across the teeth teeth crooked phenomenon. If you find the teeth broken, in general, should be a new round. What is the fault? How to correct the teeth and fill teeth? Watch teeth are not fault, usually the internal gear of the watch there is a fault caused. This type of watch failure is easy to appear in the box teeth, the central gear. In addition, because the dial dial when the wheel is too tight, across the teeth teeth crooked phenomenon. If you find the teeth broken, in general, should be a new round. But if there is no suitable accessories, it would have to fill teeth. 1, correct the watch wheel teeth, if you find the watch teeth crooked, should first remove the balance wheel and escapement fork, so that movement run strings, in order to carefully observe which wheel has resistance. Find a crooked teeth, with a screwdriver to the crooked teeth to the root, stable to the middle direction to adjust. Adjustment should be tempted when the tone, if the rush, crooked teeth not only difficult to correct, and even broken. 2, if the disc is broken, in general, should be a new round. But if there is no suitable accessories, it would have to fill teeth. The method is: with a tooth file in the middle of the teeth to open a slot, the size of the slot to not exceed half the width of the flange is appropriate, and then use the key file to make a blank into the slot. In the rough and the edge of the edge of the edge of the slope, add a little solder to heat. Heating .When burned in the excess section, so that the heat conduction to the need to heat the site, to prevent burning on the wheel, so that the disc heat and discoloration, change soft. After the solder melts, leave the alcohol lamp and then use the nail scissors forging the excess part, with the file according to the original tooth shape can be used to repair the two teeth. Beijing New World watches maintenance center official designated maintenance center, Beijing Chongwenmen New World Center Office Building B, Room 601 designated service center, is a professional maintenance of the world.

Yeezy 350 Boost V2,Adidas Yeezy 750 Boost,Adidas Zestra Chaussures,Nike Air Force 1 07,Air Force 1 Flyknit Chaussures,Air Force 1 Mid 07 Chaussures
Friend link:ADIDAS ORIGINALS NMD PRIMEKNIT,ADIDAS ORIGINALS PRIDE PACK,ADIDAS ORIGINALS STAN SMITH W,Adidas Originals Superstar Slip On W,ADIDAS ORIGINALS ZX 500,ADIDAS ORIGINALS ZX 8000